How To Disconnect The Front Camera Ribbon From The Logic Board And Reboot Your Phone
Repair guide : Proximity and Low-cal Sensor + Front Camera Cable iPhone vii
Level : Medium Time : 30 min Author : Alexandre
410 people take done this repair successfully ! Why non you?
YouriPhone 7 does non take selfies anymore ? You can't use FaceTime ? Gear up this trouble with our experts atSOSav ! Follow the steps from ourrepair guide to replace the proximity sensor/front end camera cable in just a few minutes. You lot'll save upwards to iii times the price in a repair shop, so become gear up.
Symptoms :
- Proximity sensor cablevision ripped
- Forepart photographic camera black screen
- App does non launch
- Can't utilize FaceTime
- Screen does not lock when making telephone calls
Some advice before you start
Recommended repair kit
Step 1
Earlier disassembling theproximity sensor / front end camera cable of your iPhone vii, y'all have to deeply turn it off.
Maintain the power push on the summit for a few seconds.
Then slide to the right to "power off" button in ruby-red.
Your iPhone vii is now turned off.
Step 2
With a pentalobe screwdriver, remove the two screws circled in cerise.
Those screws are on both sides of the dock connector.
Those two screws concord the bottom part of the display assembly to the iPhone.
Step three
With a hairdryer, oestrus upwardly the border of the iPhone' screen as shown in red on motion-picture show ii.
This consists in peeling the seal between the screen and the rear panel.
Step 4
Then put the suction cups as nigh equally possible to the habitation button.
Pull the cup enough to let a gap appear.
Put an opening choice between the display and rear case.
Step 5
Accept a second opening choice and slide it effectually between the display and rear example.
Footstep half dozen
Start again on the right side.
Careful when sliding the pick because the screen connectedness cable are on this side.
Step 7
Yous can at present open the iPhone by swinging the display upwards from the left side, like opening a volume !
Step 8
Utilise the Triwing screwdriver, to remove the four screws circled in ruby-red on the film.
And so with tweezers, remove the lower connector bracket
Pace 9
The lower connector bracket is at present removed.
Step 10
Utilise a nylon spudger to disconnect the brandish connector .
Footstep 11
Then unlock the second display connector.
Step 12
With a cruciform screwdriver, remove the two screws that maintain the front end panel sensor associates connector bracket.
Remove the bracket with tweezers.
Step 13
Use the nylon spudger to disconnect the front end photographic camera cable from the logic lath.
The complete screen is now disassembled.
Step 14
Remove the five cruciform screws from the earpiece speaker bracket.
Step xv
And then remove the bracket with a pair of tweezers.
Step 16
Then gently remove the front photographic camera with the nylon spudger apartment side to complimentary to the earpiece speaker.
Step 17
Take hold of the earpiece speaker with tweezers and remove it.
Step 18
Put the nylon spudger under the front photographic camera cable to start peeling off the screen.
Step 19
Continue by removing the microphone and then the proximity sensor.
The proximity sensor is very frail, you lot have to remove it very carefully.
Step 20
The proximity/light sensor/front camera cable of your iPhone 7 is now disassembled.
Y'all can supercede it by a new one.
Recommended repair kit
Source: https://www.sosav.com/guides/mobiles/iphone/iphone-7/proximity-light-sensor-frontcamera-cable/
Posted by: jaramilloicia1942.blogspot.com
0 Response to "How To Disconnect The Front Camera Ribbon From The Logic Board And Reboot Your Phone"
Post a Comment